Homelite UT70127 manual Fuel CAP, Storage 1 Month or Longer, Sparking Plug

Page 19

MAINTENANCE

FUEL CAP

WARNING:

A leaking fuel cap is a fire hazard and must be replaced immediately.

The fuel cap contains a non-serviceable filter and a check valve. A clogged fuel filter will cause poor engine perfor- mance. If performance improves when the fuel cap is loosened, the check valve may be faulty or the filter clogged. Replace fuel cap if required.

STORAGE (1 MONTH OR LONGER)

1.Drain all fuel from tank into a container approved for petrol. Run engine until it stops.

2.Clean all foreign material from the trimmer. Store it in a well-ventilated place that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

3.Abide by all ISO and local regulations for the safe storage and handling of petrol. Excess fuel should be used up in other 2-cycle engine-powered equipment.

SPARKING PLUG

This engine uses a Champion RCJ-6Y with 0.63 mm (0.025 in) electrode gap. Use an exact replacement and replace annually.

19

Image 19
Contents Save this Manual for Future Reference OPERATOR’S ManualSafety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsVibration level racing Technical DataPacking List for OWNER’S KIT FeaturesUnpacking InstructionsAttaching the Storage Hanger AssemblyAttaching the Power Head to the Trimmer Attachment Removing the Attachment from the Power HeadAttaching the Shoulder Strap Front HandleFront Handle Clamp Quick Release TAB Bolt Torque Silencer Guard AssemblyRear Housing Grass Deflector and Blade Guard USEConverting from Trimmer to Brushcutter Drive Connector Spool RetainerBlade Guard Grass DeflectorRemoving the Blade Installing the BladeInstalling the String Head Converting from Brushcutter to TrimmerFuel and Refuelling OperationOperating the Trimmer Cutting Tips Advancing the StringGrass Deflector Line Trimming CUT- OFF Blade TRI-ARC Blade Operating the BrushcutterCutting Technique Blade To Start a Warm Engine Ignition SwitchStarting and Stopping To Start a Cold EngineSee Figures 18 MaintenanceSpool Replacement EZ Line TAP Advance System NEW PRE-WOUND SpoolSpring Spool Arrows on Anchor Hole First String String ReplacementBlade Protector SlotSee Figures 25 Cleaning the Exhaust Port and SilencerReplacing and Cleaning AIR Filter Spark ArresterStorage 1 Month or Longer Fuel CAPSparking Plug Troubleshooting Idle Speed Screw Needle Sound Pressure Sound Power Vibration Model Model no WarrantySafety Directive Guarantee Statement Rtsa / Rtuk / RTGPage Ryobi Technologies GmbH