Homelite UT70127 manual Silencer Guard Assembly, Grass Deflector and Blade Guard USE, Rear Housing

Page 9

ASSEMBLY

SILENCER GUARD ASSEMBLY

See Figure 6.

1.Remove silencer guard and two screws from the owner’s kit.

2.Attach the silencer guard to the rear housing.

NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.

3.Install two screws.

4.Tighten screws securely.

GRASS DEFLECTOR AND BLADE GUARD USE

See Figure 7.

NOTE: When converting from brushcutter to trimmer, or trimmer to brushcutter, make sure the correct guard/ deflector is being used.

REAR HOUSING

 

SILENCER

TORQUE

GUARD

WRENCH

 

 

SCREWS

 

BENT END OF

 

SILENCER GUARD

 

OPENING IN REAR

 

HOUSING

Fig. 6

GRASS DEFLECTOR

FOR TRIMMER USE

BLADE GUARD FOR

BRUSHCUTTER USE

Fig. 7

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Save this Manual for Future Reference OPERATOR’S ManualSafety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsVibration level racing Technical DataUnpacking FeaturesInstructions Packing List for OWNER’S KITAttaching the Power Head to the Trimmer Attachment AssemblyRemoving the Attachment from the Power Head Attaching the Storage HangerFront Handle Attaching the Shoulder StrapFront Handle Clamp Quick Release TAB Bolt Rear Housing Silencer Guard AssemblyGrass Deflector and Blade Guard USE TorqueBlade Guard Drive Connector Spool RetainerGrass Deflector Converting from Trimmer to BrushcutterInstalling the String Head Installing the BladeConverting from Brushcutter to Trimmer Removing the BladeOperation Fuel and RefuellingOperating the Trimmer Advancing the String Cutting TipsGrass Deflector Line Trimming CUT- OFF Blade Operating the Brushcutter TRI-ARC BladeCutting Technique Blade Starting and Stopping Ignition SwitchTo Start a Cold Engine To Start a Warm EngineSpool Replacement EZ Line TAP Advance System MaintenanceNEW PRE-WOUND Spool See Figures 18Blade Protector String ReplacementSlot Spring Spool Arrows on Anchor Hole First StringReplacing and Cleaning AIR Filter Cleaning the Exhaust Port and SilencerSpark Arrester See Figures 25Fuel CAP Storage 1 Month or LongerSparking Plug Troubleshooting Idle Speed Screw Needle Safety Directive WarrantyGuarantee Statement Rtsa / Rtuk / RTG Sound Pressure Sound Power Vibration Model Model noPage Ryobi Technologies GmbH
Top Page Image Contents