Homelite UT10032, UT10512, UT10012 manual Call US First

TROUBLESHOOTING

Problem	Possible Cause			Solution
Bar and chain running	Chain oil tank empty.			Oil tank should be filled every time fuel tank is filled.
hot and smoking.	Chain tension is too tight.			Tension chain per instructions in Adjusting the Chain Tension in
				the Maintenance section of this manual.
	Oiler is not functioning.			Run at half throttle 30 to 45 seconds. Stop saw and check for oil
				dripping from SAFE-T-TIP and guide bar. If oil is present, the chain
				may be dull or bar may be damaged. If no oil is on the SAFE-T-TIP,
				contact an authorized service center.
	Clogged oil passages.			Remove the clutch cover and clean oil passages with a stiff-bristle
				brush.
Engine starts and	Chain brake is engaged.			Release chain brake. Refer to Operating the Chain Brake in the
runs, but chain is not				Operation section of this manual.
rotating.	Chain tension is too tight.			Tension chain per instructions in Adjusting the Chain Tension in
				the Maintenance section of this manual.
	Guide	bar and	chain	Refer to Replacing the Guide Bar and Chain in the Maintenance
	assembled incorrectly.			section of this manual
	Guide bar and/or chain are			Inspect guide bar and chain for damage.
	damaged.
	Drive	sprocket	teeth	Contact an authorized service center for drive sprocket replace-
	damaged			ment.

	CALL	-4672
	-242
800
1-

CALL US FIRST

For any questions about operating or maintaining your product,

call the Homelite® Help Line!

Your product has been fully tested prior to shipment to ensure

your complete satisfaction.

33