Homelite UT10510 manual Specific Safety Rules, General Precautions, Safety Apparel

Page 4

GENERAL SAFETY RULES

■ALL CHAIN SAW SERVICE, other than the items listed in the instruction manual and all maintenance, should be performed by competent chain saw service personnel. (For example, if improper tools are used to remove the flywheel or if an improper tool is used to hold the flywheel in order to remove the clutch, structural damage to the flywheel could occur and subsequently could cause the flywheel to burst.)

■KEEP SAFE-T-TIP ANTI-KICKBACK NOSE GUARD properly mounted on the guide bar to prevent rotational kickback.

■FOLLOW THE SHARPENING and maintenance instructions for the saw chain.

■USE ONLY THE REPLACEMENT GUIDE BARS and low kickback chains specified for your saw.

■DO NOT adapt your powerhead to a bow guide or use it to power any attachments or devices not listed for your saw.

■SAVE THESE INSTRUCTIONS. Refer to them fre- quently and use to instruct other users. If you loan someone this tool, loan them these instructions also.

SPECIFIC SAFETY RULES

WARNING:

The warnings, labels, and instructions found in this section of the operator's manual are for your safety. Failure to follow all instructions may result in serious personal injury.

GENERAL PRECAUTIONS

■DO NOT CUT VINES and/or small underbrush (less than 3 in./76 mm in diameter).

■MUFFLER SURFACES ARE VERY HOT during and after operation of the chain saw; keep all body parts away from the muffler. Serious burns may occur if contact is made with the muffler.

■Always hold the chain saw with both hands when the engine is running. Use a firm grip with thumbs and fingers encircling the chain saw handles.

■Never let anyone use your chain saw who has not received adequate instructions in its proper use. This applies to rentals as well as privately owned saws.

■Before you start the engine, make sure the saw chain is not contacting any object.

■Operate the chain saw only in well ventilated areas.

SAFETY APPAREL

■Wear snug fitting clothing. Always wear heavy, long pants, boots, and gloves. Do not wear jewelry, short pants, sandals, or go barefoot. Do not wear loose fitting clothing, which could be drawn into the engine or catch the chain or underbrush. Wear overalls, jeans, or chaps made of cut resistant material or ones that contain cut resistant inserts. Secure hair so that it is above shoul- der level.

■Wear non-slip safety footwear and heavy-duty gloves to improve your grip and to protect your hands.

■Wear eye protection which is marked to comply with ANSI Z87.1, as well as, hearing and head protection when operating this equipment.

REFUELING (DO NOT SMOKE!)

■To reduce the risk of fire and burn injury, handle fuel with care. It is highly flammable.

■Mix and store fuel in a container approved for gasoline.

■Mix fuel outdoors where there are no sparks or flames.

■Select bare ground, stop the engine, and allow it to cool before refueling.

■Loosen the fuel cap slowly to release pressure and to keep fuel from escaping around the cap.

■Tighten the fuel cap securely after refueling.

■Wipe spilled fuel from the unit. Move 30 feet (9 m) away from refueling site before starting engine.

■Never attempt to burn off spilled fuel under any circum- stances.

BASIC PRECAUTIONS IN THE CUTTING/ WORK AREA

■Do not operate a chain saw in a tree.

■Do not cut from a ladder, this is extremely dangerous.

■Keep bystanders and animals out of the work area. Do not allow other persons to be nearby during starting or cutting with the chain saw.

Note: The size of the work area depends on the job being performed as well as the size tree or workpiece involved. For example, felling a tree requires a larger work area than making other cuts (i.e., bucking cuts, etc.).

Page 4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Operators Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules General PrecautionsSafety Apparel Basic Precautions in the CUTTING/ Work AreaMaintenance Precautions KickbackPush and Pull See FigureSymbols Symbol Name ExplanationSpecifications Features Understanding Your Chain SAW Safety Devices OperationSAFE-T-TIP ANTI-KICKBACK Nose Guard LOW Kickback SAW ChainKickback Precautions Fuel and RefuelingHandling the Fuel Safely Mixing the FuelStarting the Engine Adding OILSee Figures 8 through Starting the Engine Stopping the Engine Preparing for Cutting Proper Grip on HandlesProper Cutting Stance See Figures 16Adjusting the Carburetor Basic OPERATING/CUTTING ProceduresWork Area Precautions See Figures 20Felling Trees Adjusting Idle SpeedHazardous Conditions Proper Procedure for Tree Felling See Figures 23 throughHinge Bucking Removing Buttress RootsBucking with a Wedge Overbucking Bucking Logs Under StressUnderbucking Limbing and Pruning Cutting SpringpolesAssembling the BAR and Chain MaintenanceSee Figures 36 through Chain Tensioning PIN Hole Chain Tensioning Screw Adjusting the Chain Tension Chain MaintenanceSee Figures 45, 46, See Figures 48Sharpening the Cutters See Figures 50 throughLeft Hand Cutters Right Hand TOP Plate Filing Angle Side Plate AngleMaintaining Depth Gauge Clearance See Figures 57, 58,Maintaining the SAFE-T-TIP Nose Guard Maintaining the Guide BARSee Figures 61 Mounting the SAFE-T-TIP Nose Guard Cleaning the AIR FilterSee Figures 63, 64, Cleaning the Starter Unit Cleaning the EngineChecking the Fuel Filter Replacing the Spark PlugChain Catcher Cleaning the Spark Arresting MufflerStoring the Chain SAW 1 Month or Longer Troubleshooting BAR and Chain CombinationsTroubleshooting Warranty Limited Warranty StatementHomelite Consumer PRODUCTS, INC

UT10510 specifications

The Homelite UT10510 chainsaw is a versatile and efficient tool designed for both novice and experienced users who require a dependable saw for various tasks, from trimming and pruning to heavier cutting jobs. Known for its power and ease of use, the UT10510 is a reliable addition to any toolbox.

One of the main features of the Homelite UT10510 is its 10-inch cutting bar, which provides a perfect balance between maneuverability and cutting capacity. This size makes it ideal for tackling small to medium-sized branches, allowing users to handle tasks quickly and efficiently. It is also lightweight, reducing user fatigue during extended use, a benefit that is particularly important for those who may need to work for prolonged periods.

The UT10510 is powered by a gas engine, providing a robust 25cc of power. This engine allows for strong performance, enabling the saw to cut through tougher materials with relative ease. Additionally, the gas-powered design offers the advantage of being more portable than electric models, as it does not require a power source or long extension cords.

Another noteworthy technology incorporated into the Homelite UT10510 is its automatic chain lubrication system. This feature ensures that the chain remains well-lubricated during operation, which not only prolongs the life of the chain but also enhances cutting efficiency. A well-lubricated chain reduces friction, allowing for smoother cuts and reducing the risk of overheating.

Additionally, the UT10510 includes a tool-free chain tensioning system, which makes it easy for users to quickly adjust the chain tension without the need for additional tools. This feature is particularly useful for those who may not have extensive experience with chainsaw maintenance, as it simplifies what can be an otherwise complicated process.

Safety is also a significant consideration in the design of the Homelite UT10510. It features a chain brake that stops the chain immediately in case of kickback. This safety feature is critical for reducing the risk of accidents while operating the saw.

In summary, the Homelite UT10510 is a compact, powerful chainsaw designed for versatility and ease of use. With its effective 10-inch cutting bar, reliable gas engine, automatic chain lubrication, tool-free chain tensioning, and built-in safety features, it stands out as a practical choice for both casual users and those looking to handle more demanding cutting tasks. Whether you need to trim branches in your yard or cut firewood, the UT10510 is designed to meet your needs efficiently.
Top Page Image Contents