5.1 Headphones (5.1 Surround)
TESTING THE SPEAKER CONFIGURATION
After selecting the speaker configuration to match your speaker system, you can check if the speakers are properly connected by clicking on the speaker icon to play a test signal on that speaker.
The buttons at the bottom of the speaker configuration illustration, labeled Test and Loop, operate as follows:
Test: When this button is clicked, the test signal automatically advances to the next speaker so that all of the speakers in a configuration are played once.
Loop: When this button is enabled, if the Test button is clicked, the test signal will continuously play in sequential order on all speakers until the Test button is turned off. If the Loop button is enabled with the Test button off, clicking a speaker will repetitively play the test signal on that speaker until the Loop button is turned off.
User’s Guide | 18 |