Honda Power Equipment H1000, H3000 manual Chute Handle

Page 16

1

3.MOWING AND MULCHING RECOMMENDATIONS

5.Install the bag support assembly on the left and right struts, while inserting the center strut pin in the the hitch plate hole.

6.Grasp the upper chute by the chute handle. Raise the upper and middle chutes, then slide the middle chute over the lower chute.

7.Install the grass bags, and secure the hopper top with its retaining band.

Cover Plate Reinstallationfor Mulching:

1.Remove the bagging kit in the reverse order of installation.

2.Install the cover plate, using the two 8 mm lock nuts. Refer to the illustration on page

10.Tighten the 8 mm nuts to a torque value of 15.2 ft-lb

(2.1 kg-m).

3.Install swirl guide B on the cover plate, using two 8 x 35 mm bolts, four 8 mm flat washers, and two 8 mm lock nuts, as shown. Tighten the 8 mm nuts and bolts to a torque value of 15.2 ft-lb (2.1 kg-m).

CHUTE HANDLE

LOWER CHUTE /

12

Image 16
Contents Page Page Afety Messages Damage Prevention MessagesPage NUT and Bolt Diameter Torque Values Dealer Installation InstructionsFt-lb Kg-m Mulching Blade 5 5 m mDealer Installationinstructions Hold swirl guide B against the cover plateSwirl Guide a 1Ox28mm Safety Label Locations H3000 Series SafetySafety Label Locations H1000SERIES Grass CUlTlNG Basics Mowing and Mulching RecommendationsMowing and Mulching Mowing and Mulching Recommendations SIDE-DISCHARGE Mowing Cover Plate Reinstallationfor MulchingConversion for Side-Discharge Mowing Bagging Conversion for BaggingChute Handle Parts List Mulching KIT Part Number 06764-763-ROOOwner Satisfaction Telephone 404