Honda Power Equipment H3000, H1000 manual Dealer Installationinstructions

Page 7

1.DEALER INSTALLATIONINSTRUCTIONS

3. Temporarily install the cover plate on the mower deck, using two 8 mm lock nuts.

A- COVER PLATE

4.Hold swirl guide B against the cover plate.

Insert a pencil through the holes in swirl guide B to mark drilling points on the cover plate.

Removethe cover platefrom the mower deck. Center punch and drill the cover plate at the pencil marks.

Use an 11/32 inch (8.4 - 8.7 mm) drill. Wear eye protection when drilling.

Remove any burrs from the holes.

SWIRL GUIDE B HOLES

5. Install the cover plate on the mower deck, using two 8 mm lock nuts.

Attach swirl guide B to the cover plate, using two 8 x 35mmflange bolts, 8 mmflat washers, and 8 mm lock nuts.

Install the bolts from inside the mower deck. Install the nuts outside the mower deck. Use washers on both sides, as shown.

Tighten all 8 mm nuts and bolts to a torque value of 15.2 ft-lb (2.1 kg-m).

8 mm LOCK

SWIRL GUIDE B

FANGE BOLT

COVER PLATE

6.Place swirl guide A in the mower deck, with one end against swirl guide B.

While holding swirl guide A in place, drill the first hole in the mower deck, using the hole in swirl guide A as a drill guide.

Use a 1/4 inch (6.2 - 6.4 mm) drill. Wear eye protection when drilling.

Remove any burrs from the hole.

3

Image 7
Contents Page Page Damage Prevention Messages Afety MessagesPage NUT and Bolt Diameter Torque Values Dealer Installation InstructionsFt-lb Kg-m 5 5 m m Mulching BladeHold swirl guide B against the cover plate Dealer InstallationinstructionsSwirl Guide a 1Ox28mm Safety Safety Label Locations H3000 SeriesSafety Label Locations H1000SERIES Mowing and Mulching Recommendations Grass CUlTlNG BasicsMowing and Mulching Mowing and Mulching Recommendations SIDE-DISCHARGE Mowing Cover Plate Reinstallationfor MulchingConversion for Side-Discharge Mowing Conversion for Bagging BaggingChute Handle Mulching KIT Part Number 06764-763-ROO Parts ListTelephone 404 Owner Satisfaction