E.INPUT AND OUTPUT CONNECTIONS
CAUTION:Whenmaking connections to this component or any other, makesure tlie poweramplifier is OFF.
CAUTION:Makesure all cable terminations are of the highest quality, free fromfrayed ends, shorts or cold soIderjoints.
1.Connect[he left and right outputs of your source com- ponents to the inputs on the KSL-2.The KSL-2is equippedwith two single-ended inputs, two balanced capable inputs, a single-endedtape input and tape output.
The single-ended and balanced inputs are labeled S-1 and S.-2, B-I and_B-2respectively, to allow customizationin the set-up ot your system. Tlie Tapeinput is labeled TAPEIN, the Tape output is labeIed TAPEOUT.There is
no difference betweenthe two single-ended inputs, or betweenthe twobalancedi.nputs.. If youhavethe optional phonoboardinstalled, it will utilize the S-1 input incl.ud- mgthe external phonoground connector. The external
phonogroundconnector is labeled GNDYou.c.anno.t use the S-1 input connectorsas a line level input whenthe phonoboardis installed.
2.Connectthe output of the KSL-2to the input of your poweramplifier. The KSL-2has both Balanced outputs
v!a standard XLRconnectors and single-ended outputs via standard RCAconnectors.
Thepin assignment for the XLRconnectors is:
pin 1-= shield (ground) | . |
p!n 2 | = non-inverting~nput(hot) |
pin 3 | = inverting input | |
NOTE:The RCAcenter conductor for each channel is wiredin parallel with pin 2, the non-invertedo, utput. Onlyone of these outputs should be connectect to a single
stereo amplifier.
NOTE:Whenconnecting inputs or outputs to the KSL-2, rememberthe balanced connections will have 6dBof gain more than the single-ended connections. Whenlevel matchingis critical in your install, keepthis specification in mind.
