2 INSTALLATION
KEYSTONE | Use to adjust the image distortion caused by tilting projection. | |
|
| (See page 24) |
AUTO POWER ON | When ON is chosen, the lamp is automatically lit when | |
|
| the power cord is plugged in the wall outlet or battery |
|
| is attached. |
|
| • The projector is in the |
|
| is off. Use the remote control to turn on the lamp. |
AUTO POWER OFF | Use to set the time elapsed before the projector enters | |
|
| the |
|
| the source. |
SLIDE SHOW | Use to adjust the slide show setting. (See page 32) | |
• | UNPLUG DEVICE | Use to properly stop the SD card input connection. |
• | AUTO START | When ON is chosen, the slide show is automatically |
|
| playback. |
• | REPEAT SETTING | Select ON for infinite(non- stop) slide show playback. |
• | INTERVAL TIME | Use to set the interval time for the slide show. |
• | TRANSITION EFFECT | Use to set the transition effect for the slide show. |
• | THUMBNAIL DISPLAY | Use to view images as thumbnail display. |
AUTO SOURCE | When AUTO is selected, the appropriate input mode is | |
|
| automatically selected depending on the input signal. When |
|
| setting AUTO SOURCE ON, the last used input is selected |
|
| automatically. When changing AUTO SOURCE from ON |
|
| to OFF under NO signal, AUTO SOURCE continues |
|
| after turning off the projector once. |
IMAGE REVERSE | Use to reverse the projected image. Select MIRROR for | |
|
| rear projection with the table |
|
| MIRROR INVERT for front projection with the ceiling- |
|
| mounted projector. |
LAMP HOUR ELAPSE | Displays the lamp’s elapsed operating time (in hours | |
|
| and minutes). |