Mitsubishi Electronics PK20 user manual EN-33, Playing an MPEG format

3-3. Playing an MPEG format

Select a movie file you want to see from the thumbnail display and press the ENTER button in the same way as displaying a JPEG image.

Press the ENTER button to stop the MPEG display and return to the thumbnail display. The thumbnail display will also return automatically when the MPEG display is over.

4. Disconnecting an SD card

Press the Unplug button on the remote control, or select [UNPLUG DEVICE] in [SLIDE SHOW] and press the ENTER button.

If you are using the remote control, a message confirming if you want to remove the SD card will appear, so use the ￿/￿ buttons to select [Yes] and press the ENTER button. Remove the SD card from the SD card slot.

Important:

The order of thumbnail and slide show display is from file names set with the fewest number of characters. If the same number of characters is used, it will be in the numerical order, and then, alphabetical order.

If a non-supported file (magnifying glass display) exists in the thumbnail display, the image cannot be displayed. It willbe skipped automatically in a slide show.

Movie files are not subjected to a slide show. They will be skipped automatically as well.

Only single-byte numners, alphabets, and some symbols can be used in a file or folder name. Non-supported charactes will be replaced with a question mark “?”.

When you unplug SD card (i.e. remove the SD card from the SD card slot), be sure to perform unplug operations either from a remote control or from a menu. Sometimes, SD card may not be recognized. If this is the case, turn on the power of the main unit again.

To use the auto-start function, place a JPEG image file on the top of hierachy.

Depending on JPEG files, the display interval during slide shows may exceed the interval time.

EN-33