Mitsubishi Electronics PK20 user manual Place of installation, EN-9, Compliance Notice Of Fcc

Models: PK20

1 52
Download 52 pages 62.1 Kb
Page 9
Image 9
Place of installation

Do not use flammable solvents (benzene, thinner, etc.) and flammable aerosols near the projector.

Flammable substances may ignite causing fire or breakdown because the temperature inside the projec- tor rises very high while the lamp is illuminating.

Place of installation

For safety’s sake, do not use the projector at any place subjected to high temperature and high humidity. Please maintain an operating temperature, humidity, and altitude as specified below.

Operating temperature: between +41°F (+5°C) and +95°F (+35°C)

Operating humidity: maximum 85%

Never put any heat-producing device under the projector to prevent the projector from being overheated.

Do not install the projector at a place that is unstable or subject to vibration.

Do not install the projector near any equipment that produces a strong magnetic field. Also refrain from installing the projector near any cable carrying a large amount of current.

Place the projector on a solid, vibration-free surface. Otherwise it may fall, causing serious injury or damage.

Do not stand the projector on a table’s end. It may fall, causing serious injury or damage.

Do not place the projector near air-conditioning unit or heater to avoid the air outlet and inlet grilles from being exposed to hot air.

COMPLIANCE NOTICE OF FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.Ifthisequipment doescauseharmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced Radio / TV technician for help.

Changes or modifications not expressly approved by Mitsubishi could void the user’s authority to operate this equipment.

COMPLIANCE NOTICE OF INDUSTRY CANADA This Class B digital apparatus complies with Canadian ICES-003.

EN-9

Page 9
Image 9
Mitsubishi Electronics PK20 user manual Place of installation, EN-9, Compliance Notice Of Fcc