Harbor Freight Tools 96156 manual Break-in Period

Page 10

slowly. Then, pull the starter handle with a rapid, full arm stroke. Once again while holding the handle, allow the rope to rewind slowly. Repeat as necessary, until the engine starts.

7.After the engine starts and warms up, slowly release the choke cable, allowing it to return to its open (run) position.

8.After each start-up, run the engine for five minutes with no load to allow it to stabilize.

9.Operate the lawn mower according to the manufacturer’s instructions.

10.After use, release the brake handle to stop the mower.

WARNING! If the engine does not stop promptly when the brake handle is released, carefully close the fuel valve. Do not use the engine again until the brake assembly has been repaired by a qualified technician.

11.To prevent accidents, turn off the engine and disconnect its spark plug wire after use. Wait for the engine to cool, clean external parts with clean cloth, then store the equipment out of children’s reach according to the Storage instructions in this manual.

Break-in Period

1.Breaking-in the engine will help to ensure proper equipment and engine operation, and will extend the engine’s lifespan.

The warranty is void if the engine is not broken in properly. The first 20 hours of operation is the break-in period.

2.During the first 3 hours of use:

Do not apply a heavy load to the mower.

3.After the first 20 hours of use:

Change the engine oil.

Under normal operating conditions subsequent maintenance follows the schedule explained in the Servicing section.

Page 10

For technical questions, please call 1-800-444-3353.

SKU 96156

Image 10
Contents For technical questions or replacement parts, please call Distributed exclusively by Harbor Freight ToolsContents Installation precautions Save This ManualOperating precautions Carbon Monoxide Hazard Using an engine indoorsService precautions Installation SpecificationsUnpacking See Figure a Make sure the hardware does not contact moving partsOperating Instructions Starting the EngineTo shut off the engine, release the mower’s brake handle Break-in Period Servicing Maintenance ProceduresAir Filter Element Maintenance SKU For technical questions, please callAfter Initial 20 Operation Hour Period Cleaning, Maintenance, Lubrication ScheduleEvery 25 Operation Hours Thereafter Storage Troubleshooting Engine will not startSuddenly Problem Possible Causes Probable Solutions Engine misfiresEngine stops Engine knocksParts List Part Description ’tyAssembly Diagram Emission Control System Warranty Please Read the Following CarefullyOwner’s Warranty Responsibilities
Related manuals
Manual 19 pages 57.78 Kb