Technical
Specifications
|
|
| 9 HP, Air Cooled, Single | |
Engine Type |
| Cylinder, 4 Stroke | ||
|
|
| Overhead Valve | |
Engine Family | 8CGPS.2702GC. | |||
Displacement | 270cc | |||
Rotation viewed from PTO | Counterclockwise | |||
(power takeoff - the output shaft) | ||||
| ||||
|
| Type | 89+ octane unleaded | |
Fuel |
| gasoline | ||
|
| |||
|
| Capacity | 1.2 Gallons | |
|
|
| 10W30 (above 32° F) | |
Engine Oil |
| Type | 5W30 (at 32° F or | |
|
|
| below) | |
|
| Capacity | 1.1 Quarts | |
Spark Plug |
| Type | F7RTC | |
| Gap | 0.028 - 0.031” | ||
|
| |||
Valve |
| Intake | .005” | |
Clearance |
| Exhaust | .007” | |
Speed |
| Idle | 1,600 RPM | |
| Maximum | 2,600 RPM | ||
|
| |||
Servicing
To prevent serious injury
from accidental starting:
Turn the Power Switch of the equipment to its “OFF” position, wait for the engine to cool, and disconnect the spark plug wire(s) before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury
from equipment failure: Do not use damaged equipment. If abnormal noise, vibration, or excess smoking occurs, have the problem corrected before further use.
Maintenance Procedures
Many maintenance procedures, including those not detailed in this manual, will need to
be performed by a qualified technician for safety. If you have any doubts about your ability to safely service the equipment or engine, have a qualified technician service the equipment instead.
Note: Warranty is void if proper mainte- nance and servicing procedures are not followed.
Engine Oil Change
CAUTION! Oil is very hot during opera- tion and can cause burns. Wait for engine to cool before changing oil.
1.Place a drain pan (not included) un- derneath the crankcase’s drain plug.
2.Remove the drain plug and, if pos- sible, tilt the crankcase slightly to help drain the oil out. Recycle used oil.
3.Replace the drain plug (and gasket, if supplied) and tighten it.
4.Refill the oil to the proper level follow- ing the instructions under the Starting the Engine section.
SKU 65761 | For technical questions, please call | Page 15 |