Basic Specifications
| Type | 89+ octane unleaded | ||
Fuel | gasoline | |||
| ||||
| Capacity | 1.2 | Gallons | |
|
| 10W30 (above 32° F) | ||
Engine Oil | Type | 5W30 (at 32° F or | ||
|
| below) | ||
| Capacity | 1.1 | Quarts | |
|
|
|
| |
Hydraulic | Capacity | 2.5 | Gallons | |
Fluid | ||||
|
|
| ||
Log Capacity | 25” L x 8” Diameter | |||
Tire Pressure | 60 PSI Cold Pressure | |||
Note: Additional specifications found in the Technical Engine Specifi- cations chart in this manual.
The emission control system for this engine is warranted for standards set by the U.S. Environmental Protection Agency and by the California Air Resources Board (also known as CARB). For warranty information, refer to the last pages of this manual.
At high altitudes, the engine’s carbu- retor, governor (if so equipped), and any other parts that control the
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental starting:
Turn the Power Switch of the equipment to its “OFF” position, wait for the engine to cool, and disconnect the spark plug wire(s) before assembling or making any adjustments to the equipment.
To prevent serious injury:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
A spark arrestor may be required.
The operator should contact local fire agencies for laws or regulations relating to fire prevention requirements.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.Due to the size and weight of the Log Splitter, assembly should be per- formed with assistance.
|
| ||
Set Up Instructions | 2. Access the Tires (48) for the following | ||
| |||
Read the entire Important | maintenance and assembly steps. | ||
|
| ||
Safety Information |
|
| |
SKU 65761 | For technical questions, please call | Page 8 | |