Guardian Technologies 004270-2 Conduit, Power Supply Cord, Isolating Different Power Sources

Page 34

Section 2 – Installation

QUIETPACT™ 75D Recreational Vehicle Generator

◆ 2.6.4 CONDUIT

 

◆ 2.6.6 GROUND FAULT CIRCUIT INTERRUPTERS

Route the connections between the generator and the junction box through approved, flexible conduit. The following general rules apply:

•All wiring, conduit, and interconnections must be installed in compliance with applicable codes, standards, and regulations.

•Cut wiring to the required length, and allow extra wire for junction box connections.

•Carefully prepare conduit ends to prevent sharp edges from cutting through wiring insulation.

•Route conduit so it does not interfere with genera- tor movement.

•If using metallic conduit, vapor-seal the end of the conduit where it enters the junction box. Do this because flexible metallic conduit is not vaporproof along its entire length.

•All openings in the generator compartment for the passage of wiring and conduit must be sealed and made vapor-tight.

NOTE:

Use a high-quality silicone rubber base sealant or other approved method (such as, explosion-proof fittings) to seal such openings.

◆2.6.5 POWER SUPPLY CORD

The power supply cord must comply with all applic- able codes, standards, and regulations. It must be large enough to handle the full amperage to which it will be subjected.

The National Electrical Code (NFPA 70, 551-7) requires that ground-fault circuit interrupters (GFCIs) be installed on all external and some internal electrical receptacles. Contact the manufacturer or dealer for recommendations.

◆2.6.7 ISOLATING DIFFERENT POWER SOURCES

Connections from the junction box must terminate in

adouble-pole, double-throw transfer switch (Figure 2.17). An alternate method for isolating different power sources includes using an isolating receptacle (Figure 2.18). Whichever method is used, be certain that both power sources are NOT connected at the same time.

DANGER

If the vehicle’s electrical circuits can be powered by any other source of electricity (such as, a “dockside” power receptacle), there must be no possibility of connecting the different power sources to the vehicle’s circuits at the same time. The dockside (utility) power source must be positively isolated from the vehicle’s circuits whenever the generator is operating. Failure to isolate the vehicle’s circuits from the dockside power supply when the generator is running may result in damage to the generator or in serious injury or death to dockside (utility) power workers due to backfeed of electrical energy. Installation and connection of the gen- erator must comply with NFPA 70, Article 551, and NFPA 1192 (latest editions).

Figure 2.17 – Transfer Switch Isolation Method

32 Generac® Power Systems, Inc.

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Liquid-cooled Recreational Vehicle Generator Authorized Service Dealer Location IntroductionPart II Installation Instructions Table of ContentsGeneral Hazards Electrical Hazards Model Generator IdentificationQuietpact 75D Generator Applicability SafetySpecifications Generator AC Connection SystemCoolant Fuel Consumption GAL/HREngine OIL Requirements EngineOptional Remote START/STOP Generator Control PanelBefore Starting the Engine Starting the Generator Stopping the Generator Protection SystemsOvervoltage Protection Additional InformationOverspeed Shutdown 1 25-HOUR BREAK-IN PeriodOperation in High Grass or Brush Checking the Engine OIL LevelChanging the Engine OIL AND/OR OIL Filter Effects of Moisture and DirtServicing the Engine AIR Filter Spark Arrestor MufflerCleaning the Generator Battery MaintenanceDrive Belt Cooling SystemEngine Coolant Exercising the GeneratorRemoval from Service OUT-OF-SERVICE ProcedureReturn to Service Service Schedule Part General Hazards Fire Hazards Equipment Description Purpose and Scope ManualStandards Booklets Generator Engine Operating SpeedMajor Features and Dimensions Generator Support Location and SupportGenerator Location Suspended MountingGenerator Restraint Generator CompartmentsCompartment Construction Sound Insulating Materials AcousticsTypical Noise Abatement 2.2.4 Compartment Floor Cutouts Cooling AIR Inlet Openings Cooling and Ventilating AIRGenerator Airflow Diesel Fuel System Testing the InstallationCompensating for Restrictions Generator Fuel Supply Lines Fuel TankGenerator Fuel Return Lines Exhaust System Exhaust System SafetyMuffler and Spark Arrestor Electrical Junction BOX WiringElectrical Connections Generator AC ConnectionsGenerator Coversion to Volts Only Dual CircuitsIsolating Different Power Sources Power Supply CordConduit Battery Cables Battery InstallationRecommended Battery Battery Cable ConnectionsBattery Compartment Optional AccessoriesRemote START/STOP Connections Before Initial Startup Post Installation TestsTesting Under Load Initial StartInstallation Checklist Troubleshooting Guide Problem Cause CorrectionAppendix 2 Notes Appendix 2 Notes Appendix 3 Electrical Data Appendix 3 Electrical Data Appendix 3 Electrical Data Wiring Diagram 120 VAC- Drawing No. 0D2793-B Part Part NO. QTY Description 677mm Item Part NO. QTY. Description 0C4554 Shaft, Fan 0C4845 Gasket, Electrical Enclosure Divider Exhaust Gasket 0C6946A Fuel Pump Assembly 023484F Snap Bushing 052219 2118 11 29 32 33 Camshaft Assembly Complete Cylinder Block Cylinder Head Assembly Crankshaft Assembly Idler Gear Assembly Rocker ARM Assemblyincludes ALL Components Shown below Injector Pump Assembly Fuel Filter Support HOUSING, Timing Gear OIL PAN Water Pump Assembly Appendix 5 Notes Manufacturers Warranty Coverage Federal and California Emissions Control Warranty StatementYour Warranty Rights and Obligations Parts CoveredObligations and Rights of the Manufacturer and Owner Obtaining Warranty ServiceLimitations Warranty Schedule CONSUMER/PERSONAL Applications

004270-2 specifications

Guardian Technologies has made significant strides in air purification technology with its model 004270-2, which stands out for its advanced features and impressive performance. Designed to enhance indoor air quality, this air purifier combines efficiency and innovation to create a healthier living environment.

One of the most notable features of the Guardian Technologies 004270-2 is its multi-layer filtration system. This system includes a true HEPA filter that captures 99.97% of airborne particles as small as 0.3 microns. This means that allergens such as dust mites, pet dander, and pollen are effectively removed from the air. In addition to the HEPA filter, the unit also incorporates a charcoal filter that eliminates unpleasant odors, making it perfect for homes with pets or cooking frequently.

The Guardian Technologies 004270-2 employs UV-C light technology to further enhance its air purification capabilities. This innovative feature works by using ultraviolet light to kill bacteria and viruses, promoting a healthier atmosphere. The combination of HEPA filtration and UV-C technology sets this model apart from standard air purifiers, providing an extra layer of protection against harmful microorganisms.

Another characteristic that contributes to the efficiency of the Guardian Technologies 004270-2 is its quiet operation. This model is engineered to minimize noise levels, making it suitable for use in bedrooms, living spaces, or offices without disrupting daily activities. Users can enjoy clean air without the annoyance of constant fan noise.

The design of the 004270-2 is also worth mentioning. Its sleek, modern appearance allows it to fit seamlessly into any room decor while being compact enough for easy placement. Additionally, the unit features a filter change indicator, ensuring that users are aware when it’s time to replace the filters for optimal performance.

Energy efficiency is another advantage of this air purifier, as it is designed to consume less power while providing powerful air purification. This not only helps in reducing electricity bills but also promotes eco-friendly practices.

In summary, the Guardian Technologies 004270-2 is an exemplary air purifier that boasts a robust filtration system, innovative UV-C technology, quiet operation, and energy efficiency. It effectively addresses common indoor air quality concerns, making it an ideal choice for households seeking a healthier atmosphere.
Top Page Image Contents