Global Machinery Company RL504 Assembly, Attaching the Handles, Cutting height adjustment

Assembly

It is necessary to fit the lower handle (2), handle bar (1), and catcher (5) to the mower.

Assembling the catcher

1.The grass catcher (5) is supplied in two sections. Locate the top half on top of the bottom half and interlock them together by aligning the lugs and slots and pushing the halves together until they click into place.

Attaching the catcher

1. Lift the discharge guard (4) in	1
order to position the catcher.

2.While lifting the discharge guard, slide the catcher into position in adownwards

direction (Fig. 1).

3. Push the catcher down until it locks into place (Fig. 2).

4.Release the discharge guard to secure the catcher in place between the 2 ribbed locking notches (Fig. 3).

Note. Always empty the catcher before it has reached maximum

2 3

capacity, otherwise it will decrease the performance of the mower.

Attaching the Handles

It is necessary to attach both the lower handle and handle bars.

1.To attach the lower handle, first use a spanner to remove the 4 bolts.

2. Place the lower handle in position and replace the 4 bolts. Use the spanner to retighten the nuts.

3.To attach the handle bar, first remove the two handle bar locking knobs (13).

4.Position the handle bar over the lower handle and insert the two locking knobs, and tighten to secure the handles together.

Cutting height adjustment

The GMC mower has one lever to easily adjust the cutting height.

There are 10 height settings.

1.To decrease the cutting height pull the height adjustment lever (6) out and move it up a notch, towards the handlebar.

2.To increase the cutting height pull the lever out and move it down a notch, towards

the motor.

8