D.BASIC INSTALLATION AND OPERATION
1.Place the unit on a firm level surface free fromexces- sive dirt or moisture..The KRC-is2 not particularly hum sensitive, therefore other componentscan be placed on or around the KRC-2.
2.If youare using the separate. KPEph.onostage with the KRC-2,the following connections apply:
NOTE:If you are not using the KPEproceed to step 3.
a.Unplugthe KRC-2from the wall ACreceptacle.
b.Locate the 9 pin DCpowerconnector labeled KPE POWER.
c.Connectthe KPEwith the DCpowercable supplie.d with the phono stage, to the KPEPOWERinput on the KRC-2.
d.Plug the KRC-into2 the wall AC.receptac.le..The Pilot LEDon the KPEshould illuminate along with the
KRC-2The.input select will default to the mutepo.sition. Should the KPEpilot LEDnot illuminate, unplug the
KRC-2from the wall ACreceptacle and check aI1 qf your connections. Shouldyouhave difficulty poweringtlae KR.C-2and the KPEtogether please contact Krell for
assistance.
3.If you. are not using the .KPE,plugthe ACcord into the receptacle on the back of the umt. Plug the remainingend into the .wall ACreceptacle.Thepilot LEDwill illumi- nate, and the KRC-2will default to the Muteposition.
NOTE:While the KRC-2has superb regulation and does not require a dedicated ACcircuit, westrongly advise against any. connections through extension cords or mul- tiple ACadaptors. Highquality 15 ampline conditioners or groundedACstrips are acceptable.
NOTE:The KRC-2provides two special remote connec- tors on the.backpane]. Theseare provided for future room remoteand remote slave formats. Please consult the KRELLstaff for assistance on these developments.
