Remote Control, Battery Installation | Krell Industries KRC 2

G.REMOTE CONTROL

1. Whena function button on the remote control is

~ssed, the blue pilot LEDwill flash on the KRC-2. en the button is released the flashing stops.

2.Thefunctions of the remotecontrol are described below:

UP arrow	volumehigher
DOWNarrow	volume lower
S 1	selects	S 1 input
$2	selects	$2 input
$3	selects	$3 input
$4	selects	$4 input
B1	selects	B 1 input
B2	selects	B2 input
TAPE	selects Tapeinput and allows tape
	monitoring
PHASE	0 or 180 degrees
	LEDilluminates whenthe phase is
	reversed 180 degrees
GAIN	Low 6 dB High 12 dB
	LEDilluminates in high position
MUTE	Nosignal output with LEDon
BALANCE <	Left channel attenuation in 1 dB
BALANCE >	increments and OFF
	Right channel attenuation in 1 dB
	increments and OFF

NOTE:Batteries should be replaced whenthe KRC-2 functions fromthe remotecontrol are not readily accessible.

1.Removethe four hex head screws from the bottom 12ortionof the remotecontrol's front plate.

2.llemovethe back plate to exposethe battery storage

compartment.

3.Insert batteries (Refer. to the polarity drawingwhile inserting the batteries)

4.Replacethe back plate and insert the four hex head screws.