E.INPUT AND OUTPUT CONNECTIONS
CAUTION:Whenmaking connections to this component or any other, makesure tlie poweramplifier is OFF.
CAUTION:Makesure all cable terminations are of the
highest quality, free from frayed ends, shorts or cold solder joints.
1.Connectt.he left and right outputs of your source com- ponents t.o the inputs on the KRC-2.The KRC-2is equipped with 4 single-ended inputs., 2 balanced capable inputs, a single endedtape input and tape output.
The single-ended and balanced inputs are labeled S-1 througti S-4, B-1 a.nd B-2 respectively, to allow customization in the set-up otyour system. There is. no difference between the four single-ended inputs, or ~e- tween the two balanced inputs.
2.Connect the output of the KRC-2to the input of your power amplifier. The KRC-2has both Balanced outputs via standard XLRtype connectors and single-ended outputs via standard-RCAtype connectors.
Thepin assignment for the XLRconnectors is: pin _1-= shield (ground)
p!n 2 = non-inverting input (hot) pin 3 - inverting input
NOTE:The RCAcenter conductor for each channel is wired in para!lel with pin 2, the non-inverted output. Only one of these outputs should be connected to a single stereo amplifier.
NOTE:Whenconnecting inputs or outputs to the KRC, remember the balanced connections will have 6dB of
gain .m.ore than the single-ended connections. Whenlevel matchingis critical in your install, keep this specification in mind.
