WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
DOWNROD
HAIRPIN
CLIP 
SETSCREW
MOTOR
COUPLING
CLEVIS PIN
DOWNROD
HAIRPIN | CLEVIS PIN | |
CLIP | ||
|
MOTOR
COUPLING
Figure 12
23.Install the setscrew (supplied) in the motor coupling and tighten using the 5/32” setscrew wrench (supplied) (Figure 13).
DOWNROD
HAIRPIN
CLIP 
SETSCREW
MOTOR
COUPLING
CLEVIS PIN
DOWNROD
Figure 13 | 5/32" SETSCREW |
WRENCH |
24.Screw two
DOWNROD
7/8"
MOTOR
COUPLING
Figure 14
25.Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude. Install one lockwasher (supplied) and one knurled knob (supplied) onto each threaded stud to secure the cover to the motor. All wires and wire connectors must be enclosed under the motor cover (Figure15).
NOTE: Lightly snug the knurled knob and make sure the wires and wire connectors are completely inside the motor coupling cover and not pinched between the motor coupling cover and the motor.
DOWNROD | KNURLED KNOB |
| (1 PER STUD) |
MOTOR COVER
LOCKWASHER
(1 PER STUD)
THREADED STUD
Figure 15
IMPORTANT
A.If you have installed the 12” or optional longer downrod and are planning to install the decorative scroll assembly, proceed to “Installation of the Decorative Scroll Assembly” on page 8. After you have installed the decorative support rods assembly, continue with the following installation procedures.
B.If you have installed the 6” downrod, continue now with the following procedures.
26.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large opening at the top (Figure 16).
27.Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 16). Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
PIN |
|
SETSCREW | HANGER |
BALL | |
DOWNROD | CEILING |
COVER |
7 Figure 16 | U.L. Model No.: CF3200 |