Partially Assembled Ceiling FAN Styrofoam

7.Remove the wire connector from the white wire of the switch housing plate. Retain for the next step.

8.Connect the white wire from the switch housing plate to the white wire of the switch housing, using the wire connector previously removed (Figure 3).

9.Connect the 9-pin connector from the switch housing plate to the 9-pin connector of the switch housing (Figure 3).

SWITCH HOUSING

WIRE CONNECTOR

SWITCH HOUSING PLATE

WHITE WIRE

9-PIN CONNECTOR

SWITCH HOUSING

WHITE WIRE

Figure 3

10.Tuck all wires into the switch housing, opposite of the switch housing notched hole (Figure 4).

NOTE: If installing an optional Emerson light kit, follow the instructions provided with the light kit.

12.Carefully turn over the partially assembled ceiling fan and place the onto the flat surface of the styrofoam (Figure 6).

PARTIALLY ASSEMBLED

CEILING FAN

STYROFOAM

Figure 6

NOTE: It may be necessary to remove the rubber clips in order to install the light kit glass. Make sure rubber clips are reinstalled so as to securely hold the light kit glass.

13.Gently place the light kit glass into the decorative light kit ring (Figure 7).

14.Rotate the rubber clips to secure glass into place. (Figure 7). You may need to tighten the screws on the rubber clips to secure.

ALL WIRES AND CONNECTORS LOCATION

SWITCH

HOUSING

SWITCH HOUSING PLATE NOTCHED HOLE

RUBBER CLIP		RUBBER CLIP (3)
SCREW
		LIGHT KIT GLASS

DECORATIVE LIGHT

KIT RING

LIGHT KIT

GLASS

Figure 4

NOTE: Be sure wires are on the opposite side of the notched hole before securing the switch housing.

	11. Secure the switch housing to the switch housing
	plate using three #8-32 x 10mm flat head screws	Figure 7
	(supplied) (Figure 5).	Figure 7
	(supplied) (Figure 5).
	SWITCH HOUSING
	#8-32 x 10mm FLAT
	HEAD SCREW (3)

Figure 5

5	U.L. Model No.: CF3200