Troubleshooting 10/100Base-TX/9000

 

 

Diagnostic Flowcharts

 

Flowchart 3 Procedures

 

Check that your 10/100Base-TX connectors to the card and hub (or wall

NOTE

 

plug) are fully connected before beginning this flowchart.

 

A.

Execute: lanscan. Enter the lanscan command to

 

 

 

display information about LAN cards that are

 

 

successfully bound to the system. See the lanscan

 

 

online manpage for more detailed information.

 

B.

Is your interface displayed? lanscan shows

 

 

information about every LAN card in the system

 

 

backplane. The Hardware Path of one of the entries

 

 

should correspond to the HP-PB 10/100Base-TX card

 

 

slot multiplied times 4. For example, a hardware path

 

 

of 32 corresponds to an HP-PB 10/100Base-TX card in

 

 

slot 8.

 

C.

Hardware up.The hardware state is operational if up is

 

 

displayed for the 10/100Base-TX card under the

 

 

Hardware State heading. If it is, continue to flowchart

 

 

5. If not, go to D.

 

D.

Run ioscan. ioscan will scan the system hardware

 

 

and list the results. If you execute ioscan -f, output

 

 

similar to the following will be displayed:

Chapter 4

65