HP PB 10 Card, Power, = LED ON, = LED OFF, Figure B-2, Test LED=ON, Activity = OFF, RJ-45Connector (TX), Link Status LED = OFF, 100-Mbit/sIndicator = ON

Hardware Reference Information

Basic Troubleshooting Tips

	if the Test LED is ON, this indicates a fault.
	The possible causes of a fault condition could be:
	• Defective cable
	• Cable not connected to active hub or switch
	• Defective card
	If the Link LED is ON and the Test LED is OFF and there still is a fault,
NOTE
	at the HP-UX command line, type: dmesg and view the output on your
	screen to see if any error messages exist.
Figure B-2	LED Display Indicating Fault Conditions for 10 or 100 Mbit/s
	Card

	= LED ON
	= LED OFF
Power	Test LED=ON
RJ-45 Connector (TX)
100-Mbit/s Indicator = ON	10-Mbit/s Indicator(ON for 10Mbit/s)
Activity = OFF	Link Status LED = OFF

10 or 100 Mbit/s

Appendix B 97