Installing and Configuring 10/100Base-TX/9000
Step 6: Configure the 10/100Base-TX LinkStep 6: Configure the 10/100Base-TX LinkMake sure the 10/100Base-TX card and software are installed in the system before you use SAM to configure the software.
The instructions below are for the Motif version of the System Administration Manager (SAM). To activate the X11 software on your system, you must first run the command: .
export DISPLAY=system name:0.0
Log in as root and do the following:
1.At the HP-UX prompt, type: sam
2.Double click Networking and Communications at the SAM main window.
3.Double click Network Card Configuration at the Networking and Communications window.
4.Highlight the HP-PB 10/100Base-TX interface card that you want to configure from the object list. If the card is not displayed, then go back to Step 3 “Access the System Card Bay” and check that your hardware has been properly installed.
The term 10/100Base-TX on the display indicates that a 10/100Base-TX card is present. To determine the speed of the 10/100Base-TX card you must run lanadmin and reference the link speed at the LAN Interface Status Display or check the 10 and 100 Mbit/s LEDs on the 10/100Base-TX card.
The SAM object list always shows the name of the built-in LAN (IEEE802.3/Ethernet) as lan0 and the first networking card in an HP-PB slot as lan1. The networking cards installed in other slots are named sequentially (lan2, lan3, etc.), according to the order of the occupied slots.
