Installing the Power Connector

1.Align the power connector to its position in the computer.

2.Place the power-connector bracket on the power connector.

3.Tighten the screw to secure the power-connector bracket to the computer.

4.Route the cable through the routing channel.

5.Connect the cable to the system board.

6.Install:

a.base cover

b.base corner cap (right)

c.battery

7.Follow the procedures in After Working Inside Your Computer.

Removing the Heat-Sink Assembly

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a.battery

b.base cover

3.Disconnect the fan cable and remove the screws that secure the heat-sink assembly to the system board.

23

Page 23
Image 23
Dell E6540 owner manual Installing the Power Connector, Removing the Heat-Sink Assembly