Light KIT Assembly | Emerson CF3200AWL00 instruction

15.Securely connect the white fan one-pin connector wire to the white one-pin connector wire from the light kit assembly. Connect the yellow fan one-pin connector wire to the yellow light kit assembly one-pin connector wire (Figure 8).

LIGHT KIT

ASSEMBLY

YELLOW LIGHT KIT ASSEMBLY WIRE

WHITE LIGHT KIT

ASSEMBLY WIRE

ONE-PIN

CONNECTOR

YELLOW

FAN WIRE

WHITE FAN WIRE

Figure 8

16.Install four 15-watt candelabra base light bulbs in the light kit assembly sockets (Figure 9).

15-WATT CANDELABRA BASE LIGHT BULB (4)

LIGHT KIT

ASSEMBLY

SOCKET (4)

Figure 9

17.Unscrew and save one of the three screws in the light kit adapter. Position the light kit assembly onto the light kit adapter, making sure the wires are positioned through a notched hole before securing (Figure 10).

18.Rotate the light kit assembly so that the two screws engage in the keyholes slots. Secure the light kit assembly to the light kit adapter by threading the previously removed screw into the remaining hole. Tighten the three screws securely at this time. (Figure 10).

NOTE: Do not pinch wires between the light kit assembly and the light kit adapter.

LIGHT KIT
ASSEMBLY	LIGHT KIT
SCREW (3)	ASSEMBLY	NOTCHED
KEYHOLE		HOLE
KEYHOLE
SLOTS

NOTCHED

HOLE

Figure 10

19.Obtain the hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 11). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 27. Discard the 12” downrod if using the 6” downrod.

HANGER BALL

DOWNROD	SETSCREW

Figure 11

NOTE: The longer downrod (12”) furnished with the ceiling fan provides the minimum recommended floor-to-fan blade clearance for a 9-foot ceiling. The 6” downrod (supplied) is to be used for shorter ceilings.

20.Separate, untwist and unkink the black, white and blue motor wires and the yellow uplight lead. Route these wires through the downrod.

21.Fold the wires from the downrod into the slot in the motor coupling. Then slide the downrod down the wires and seat the downrod in the motor coupling (Figure 12).

22.Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 12). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose.

6	U.L. Model No.: CF3200