EarthQuake 9070300, 9050140, 9060140 Install the Hopper All Models, Install the Handle All Models

Install the Hopper - All Models

1.Attach the hopper to the rotor housing. Make sure to engage the metal lip of the hopper liner inside the housing.

2.Secure the hopper to the rotor housing using two 5/16 x 1/2 hex head bolts, two 5/16 flat washers (Figure 19). Do not tighten hardware at this time.

3.See Figure 20. From the inside of the hopper install one 5/16-18 flange nut on each 5/16 weld stud. Finger tighten only at this time.

4.Check that the hopper is seated correctly and tighten all hardware.

Install the Handle - All Models

1.Lift the hopper handle up until the outer holes in the handle align with the holes in the shredder hopper and secure with 1/4-20 x 3/4 screws, washers, and nuts (A, Figure 21). Insert the screws from the outside of the shredder hopper.

Initial Assembly

Figure 20. Installing Hardware Inside the Hopper

A

Figure 21. Installing the Hopper Handle

A. 1/4-20 x 3/4 Screw & Nut

Figure 19. Attaching the Hopper

1-800-345-6007

GetEarthquake.com

Page 11