12 
starting cold engine
1.Stop Switch
Move stop switch button (A) away from the STOP position.
2.Throttle Position Lever
Move throttle position lever (B) midway between idle and full throttle positions.
3.Choke
Move choke (C) to Cold Start ( 
) Position.
4.Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the clear fuel tank return line.
IMPORTANT
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for start-
ing. Do not allow the rope to snap back in. Always hold the unit
firmly.
5.Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip with left hand and rapidly pull recoil starter handle/rope (E) until en- gine fires , or maximum 5 pulls.
6.Choke
Move choke lever (C) to Run position, and if necessary, restart engine.
NOTE
If engine does not start after 5 pulls, repeat instructions
7.After engine warm up, gradually depress throttle trigger to in- crease engine RPM to operating speed.
NOTE
Allow engine to warm up 3 minutes before use.
A |
B |
C | D |
E |
C |