Echo CS-303T instruction manual Preparation For Use, Tip Guard to Bar Instructions

CS-303T DESCRIPTION

Preparation For Use

Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.

Note: The machine may be delivered with guide bar, tip guard, and saw chain separated. Install guide bar, tip guard, and saw chain as follows.

Tip Guard to Bar Instructions

Tools Needed: Two 11 mm (7/16 in.) Wrenches. For saws with tip guard P/N 2894901 and Symmetrical or Asymmetrical Low-Kick type (Double Guard) guide bars.

1.Install bolt (A) in rear hole (B) of tip guard and through front hole (C) in guide bar.

2.IMPORTANT: Dimple (D) in tip guard must engage recess (E) in guide bar.

3.Securely tighten nut (F) and bolt (A).

Guide Bar and Saw Chain Installation/Removal

1.Release the cylinder cover latches, and remove the cylinder cover.

2.Remove spark plug lead.

3.Remove sprocket guard nuts (A) and remove sprocket guard

(B).

4.Remove guide bar and saw chain if necessary.

Note: See “Maintenance and Care” section for guide bar/saw chain maintenance procedures.

For more information scan this QR code.

A

D

B

E

C

F

For more information scan this QR code.

A

B

X7503207802 15

© 08/2013 ECHO Inc.