Dixon Complete Specifications for the ZTR 2301 Lawn Mower

SPECIFICATIONS

		Model ZTR 2301
CHASSIS:	Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY:	All body parts are made of rotational molded polyethylene. Front body
	contains	access panel for battery service. Seat tilts forward to allow
	transmission service.
MOWER DECK:	11 GA stamped steel construction.
	Single 30" cut blade.
	Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE:	Mechanical; hand lever engagement.
TRANSMISSION:	Each rear wheel is independently driven by chain and sprockets through a
	friction mechanical drive.
ENGINE:	16 HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-
	Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
	Aluminum Head and Block with Cast-Iron Cylinder Liner. Smart Spark
	Ignition.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and
	blade drive.
TIRES:	Front	11 X 4.00-5 ribbed tread.
	Rear	16 X 6.50 X 8 Multi-Trac.
RECOMMENDED	Front	16-21 PSI.
TIRE PRESSURE:	Rear	8-14 PSI.
CAPACITIES:	Fuel	2.0 gallons total.
	Engine	1.25 quarts oil.
DIMENSIONS:	Width	32.5" outside rear wheel measurement.
	Height	32.0" to top edge of seat.
	Length	65.5" hitch tab to front bumper.
	Weight	440 lbs.
NOTE:	Additional information provided in service instructions under the individual
	component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

Page 3