Dixon ZTR 2301 manual Cutter Blade Maintenance

Page 30

CARE AND MAINTENANCE

CUTTER BLADE MAINTENANCE:

NOTE: Observe proper blade position prior to removal.

1.Safely raise front of mower.

2.Hold or block blade from turning.

3.Loosen blade nut and remove blade.

4.When replacing blade, tighten blade nut securely. Refer to diagram.

CAUTION

NOTE:

Wear heavy, thick gloves when holding onto cutter blade, avoid the sharp edge of the blade.

Be sure blade is centered on pilot before tightening nut to 60 ft. lbs. torque.

Page 30

Image 30

Contents Model ZTR Dixon Limited Warranty Policy -- Model ZTR Chassis DimensionsSpecifications Subject to Change Without Notice BodySpare Parts Series Important Read Carefully Dixon INDUSTRIES, INCIndex Safety Safety Symbols General Operation Slope Operation Do notChildren Service Dixon Protection Plus TWO Year Limited Warranty Policy Specifications Model ZTRShroud Mower Decks Seat Adjustment Instructions Models ZTR 3303 ZTR 3304 ZTRControls Parking Brake To SET Parking BrakeTransmission Drive System Turning To GO ForwardTo GO Backward BrakingCircuit Breaker Operation Instructions Before Operating MowerTesting of Safety Interlock Systems Engine should not turn over or attempt to startStarting Instructions Mowing with a Mulching Attachment CUT High MOW OftenMowing with a Grass Catcher Attachment Maintain Sharp Blades Throughout The Cutting SeasonSide Discharge of the Clippings Grass Height SuggestionsCare and Maintenance Maintenance ScheduleBattery Cutter Blade Maintenance Belt Tension Deck REMOVAL-MANUAL CLUTCH-MODELS 3303Deck Removal Electric Clutch Model ZTR Place cut height lever in lowest cut positionLubrication Service IntervalsFuel Shut OFF Valve LocationsChanging the Engine OIL OIL FillDrive System Adjustments Rear Chain AdjustmentPARTS/SERVICE Cleaning the MowerWarranty Wheels and TiresBlades Standard Service Parts ListBriggs & Stratton AIR Filter Part Numbers BeltsTroubleshooting Mower CUT QualitySituation Causes Remedy Drive System Electrical System Owner Information Date OIL Changed Date Engine TunedSeries