Dixon ZTR 2301 manual Deck Removal Electric Clutch Model ZTR

Page 32

CARE AND MAINTENANCE

DECK REMOVAL - ELECTRIC CLUTCH

MODEL ZTR 3014

1.Place cut height lever in lowest cut position.

2.For 36" decks, loosen nut on belt idler shock mount until belt can be removed from electric clutch pulley on the bottom of the engine. Refer to illustration below.

For 42" decks, pull belt idler back to allow belt to be removed from idler pulley and electric clutch pulley.

3.Remove hair pin cotter and washer from one end of deck support cross shaft. Note location of remaining shim washers used between chassis and mower deck pan arms. Slide shaft from chassis and mower deck.

4.Remove hair pin cotter and washer from each deck adjustment rod. Carefully push each link toward the inside of the mower chassis. At this point, deck will drop down.

5.Carefully raise and support front of chassis. Slide mower deck to either side for removal. (Reverse procedure to reinstall deck assembly).

Page 32

Image 32

Contents Model ZTR Dixon Limited Warranty Policy -- Model ZTR Dimensions Specifications Subject to Change Without NoticeChassis BodySpare Parts Series Important Read Carefully Dixon INDUSTRIES, INCIndex Safety Safety Symbols General Operation Slope Operation Do notChildren Service Dixon Protection Plus TWO Year Limited Warranty Policy Specifications Model ZTRShroud Mower Decks Seat Adjustment Instructions Models ZTR 3303 ZTR 3304 ZTRControls Transmission Drive System Parking BrakeTo SET Parking Brake To GO Forward To GO BackwardTurning BrakingCircuit Breaker Operation Instructions Before Operating MowerTesting of Safety Interlock Systems Engine should not turn over or attempt to startStarting Instructions Mowing with a Mulching Attachment CUT High MOW OftenMowing with a Grass Catcher Attachment Maintain Sharp Blades Throughout The Cutting SeasonSide Discharge of the Clippings Grass Height SuggestionsBattery Care and MaintenanceMaintenance Schedule Cutter Blade Maintenance Belt Tension Deck REMOVAL-MANUAL CLUTCH-MODELS 3303Deck Removal Electric Clutch Model ZTR Place cut height lever in lowest cut positionService Intervals Fuel Shut OFF ValveLubrication LocationsChanging the Engine OIL OIL FillDrive System Adjustments Rear Chain AdjustmentCleaning the Mower WarrantyPARTS/SERVICE Wheels and TiresStandard Service Parts List Briggs & Stratton AIR Filter Part NumbersBlades BeltsSituation Causes Remedy TroubleshootingMower CUT Quality Drive System Electrical System Owner Information Date OIL Changed Date Engine TunedSeries