Dixon 36 manual Neutral Adjustment

CARE AND MAINTENANCE

NEUTRAL ADJUSTMENT

DRIVE MACHINE UNTIL HYDROSTATIC TRANSMISSIONS HAVE WARMED UP. WITH ENGINE RUNNING AND THE PARKING BRAKE OFF, SWING THE CONTROL LEVERS OUTWARD. IF MACHINE STARTS TO CREEP, FOLLOW THE INSTRUCTIONS BELOW.

1.Stop the engine, engage parking brake and raise rear of frame with jack or blocks so that rear tires do not contact the ground.

2.Swing out the control levers, start the engine and release the parking brake.

3.Raise the seat to access hydro control linkage. If right wheel creeps, adjust right side linkage and vice-versa. Use procedure below.

a.Loosen jam nuts on ends of the coupler P/N 7736.

b.If either wheel is creeping forward, turn coupler clockwise until neutral is achieved. If either wheel is creeping backward, turn coupler counter-clockwise until neutral is achieved.

c.Tighten jam nuts against coupler.

4.Stop engine and remove rear of machine from jack or blocks.

(See Illustration on page 43)

42