Dixon 5421 manual Specifications

Page 8

CHASSIS:

BODY:

SEAT:

MOWER DECK:

BLADE DRIVE: DRIVE SYSTEM:

ENGINE:

STARTING SYSTEM:

TIRES:

CAPACITIES:

DIMENSIONS:

NOTE:

SPECIFICATIONS

11 GA - rectangular tube.

Two piece - made of rotational molded polyethylene. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

Designed for operator comfort by use of high density closed cell foam, padded back and arm rests. Seat is adjustable fore and aft.

13 GA stamped steel construction, 3 blades, 42" cut width, cut height approximately

1 " to 4" via 7 position lift handle.

Electric clutch.

Each rear wheel is independently driven by a Hydro Gear BDU-10L Series 70 hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully enclosed Hydro Gear gearbox. The gears in the Hydro Gear gearbox are permanently lubricated using a special grease which completely eliminates the need for any type of maintenance.

The Hydro Gear BDU-1 OL Series 70 hydrostatic transmissions are serviced with any high quality 10W-30 motor oil. The oil is filtered by a 10 micron oil filter. Recommended service interval for filter is after the first 250 hours of operation, then after every 400 hours of operation. If the system becomes contaminated by dirt or other foreign debris, both oil and filter must be replaced immediately.

16 HP Kohler Magnum, Vertical Crankshaft, 4-Cycle, Air Cooled, Gasoline, Twin Cylinder Opposed, Aluminum Crankcase, Removable Cast Iron Cylinder Barrels, Electronic Ignition, Full Pressure Lubrication.

Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Front 1 1 X 4.10 X 4 smooth profile.

Rear 1 8 X 9.5 X 8 turf savers.

Fuel - 4.8 gallons total (dual tanks). Hydrostat oil tank - 3 quart with inline 10 micron filter. Hydrostat oil recommendation - name brand SAE 10W-30 motor oil.

Width 51"

Height 45"

Length 72"

Weight 615lbs.

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

Page 5

Image 8
Contents Page Important Read Carefully Index Safety Safety Reminders Read Carefully Before Operation Safety Reminders Dixon Limited Warranty Policy -- HYDRO-GEAR Models Specifications SET UP and Service Seat Assembly Instructions Upper Control Lever Installation Mower Deck Installation Mower Deck Leveling Procedure Leveling PrincipalsFinal Preparation Mower Deck DeflectorOperation Instructions To GO ForwardOperation Instructions Care and Maintenance Model Procedure for Electric Clutch Adjustment Ohms TestBelt Tension Care and Maintenance Model Page Forward Lever Stop Adjustment Chassis and Mower Deck Number of grease zerks used Cleaning the Mower Troubleshooting Drive System Electrical System Page Page Page Page Page Page Page Page Page ZTR 5421 Parts List ZTR 5421 Parts List Rear Rim Lift Cam Drilled RH Page Page Page FAX 316 251