Page 7
SEAT ASSEMBLY INSTRUCTIONS
1.Assemble seat as shown in picture. Do not fully tighten the bolts which secure left and right arm rest brackets to seat bottom until seat back and tool box are installed. This will aid alignment of all parts.
2.Place seat assembly on rear body cover, connect seat safety switch.
3.Insert the (2) cover. Firmly body is raised
rear studs of the seat slide into the rear holes of the body hold seat assembly against body cover with one hand while rear to fully open position. Continue to hold seat against body to
prevent damage to seat safety switch wiring.
4.Install (1) flat washer and (1) nylok nut on (1) of the rear studs extending through body cover and seat frame, tighten a few threads to hold seat assembly in place.
5.Position seat on front holes and install all remaining washers and nylok nuts. Tighten all nuts fully.