Specifications

		Model ZTR 3303
CHASSIS:	Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY:	All body parts are made of rotational molded polyethylene. Front body contains
	access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECK:	11 GA stamped steel construction.
	Single 30" cut blade.
	Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE:	Mechanical; hand lever engagement.
TRANSMISSION:	Each rear wheel is independently driven by chain and sprockets through a
	friction mechanical drive.
ENGINE:	10.5 HP I/C Briggs & Stratton, 4-Cycle, Single Cylinder, Air-Cooled, Gasoline,
	Vertical Shaft, Aluminum Head and Block.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and
	blade drive.
TIRES:	Front	11 X 4.00-5 ribbed tread.
	Rear	16 X 6.50 X 8 Turf Trac R/S tread.
RECOMMENDED	Front	16-21 PSI
TIRE PRESSURE:	Rear	8-14 PSI
CAPACITIES:	Fuel	2.0 gallons total.
	Engine	1.25 quarts oil.
DIMENSIONS:	Width	32.5" outside rear wheel measurement.
	Height	32.0" to top edge of seat.
	Length	65.5" hitch tab to front bumper.
	Weight	430 lbs.
NOTE:	Additional information provided in service instructions under the individual
	component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

Page 11

SPECIFICATIONS