Dixon 13282-0801 Grass Height and Cutting Suggestions, Do not attempt to cut grass when it is wet

Page 24

OPERATION INSTRUCTIONS

GRASS HEIGHT AND CUTTING SUGGESTIONS:

Do not attempt to cut grass when it is wet.

If the grass is tall, place the mower deck cut height lever in the top or second notch. “Initially” overlap cutting swaths instead of a full swath with each pass. Some applications may require a second cutting.

Keep the underside of the mower deck clean.

Maintain sharp blades throughout the cutting season.

As a rule of thumb, never cut off more than 1/3 of the total grass blade length.

Correct mowing height can reduce weeds and disease by 50% to 80%.

The following grass cut heights are based an adequate moisture conditions and normal thatch buildup in a healthy lawn. Some locations and applications may require slightly different cut heights. If in doubt, consult your local lawn professional for assistance.

Grass Types

Best Cut Heights

Bermudagrass

1 - 2”

Bluegrass

2 - 3”

Buffalograss

11/2 -3”

Ryegrass

2 - 3”

Tall Fescue

3-31/2

Zoysiagrass

1 - 3”

24

Image 24
Contents Manual Important Read Carefully Index Safety Safety Alert Symbol General Operation General Operation Slope Operation Do not mow itChildren Never allow children to operate the mowerService Service Dixon Limited Warranty Policy Commercial Models Specifications Series Diesel VersionControls Control LeversParking Brake Mower Deck LiftControls SeatMower Blade Switch Ignition SwitchThrottle Control Lever Circuit BreakerControls Operation Instructions Before Operating MowerTesting of Safety Interlock Systems Interlock Switch Test Starting Instructions Stopping InstructionsMowing Instructions Do not attempt to cut grass when it is wet Grass Height and Cutting SuggestionsTo Lift Seat SpringsTo Free Wheel Machine Towing Care and Maintenance Maintenance ScheduleBattery EngineTires Mower Blades BeltsLubrication Checking & Replenishing OIL in Hydrostatic Transmission Dirt or water in oil can ruin Hydrostatic transmissionsParking Brake Adjustment Headlight Adjustment Hydrostatic Pumps Hydrostat Drive BeltTo remove hydrostat pump drive belt Hydrostat Drive Belt Replacement Procedure To install hydrostat pump drive beltSteering Control Adjustments To adjust neutralTo adjust neutral springs Steering Control Adjustments To adjust steering control leversTo adjust In position of the steering controls To adjust for straight forward trackingLeveling the Deck Troubleshooting Engine Overheated Model ZTR 8026D Briggs & Stratton AIR and OIL Filter Part NumbersModel ZTR 8026D 26 HP Owner Information ZTRMowers