Dimension One Spas 01513-192 manual Light

	Aquatic Fitness System
	2005 Owner’s Manual
Term (Cont.)	Definition
Heater	An 11kw 230v thermostatically controlled electric heater
	equipped with a high-limit temperature safety shut-off switch.
	If the high-limit safety switch trips, contact your authorized
	Aquatic Fitness System Dealer. See the Troubleshooting
	Guide for more information.
Jets	Return the water into the Aquatic Fitness System from the
	equipment. The HydroTherapy Jets produce a turbulent flow
	of water mixed with air to provide a concentrated body
	massage. The Swim Jets produce a high volume flow to
	provide a rapid current for swimming.
Light	Illuminates the Aquatic Fitness System vessel.
Load Sharing	When the circuit breaker size is smaller than the total power
	needed to operate both the heater and the jet pump at the
	same time, load sharing automatically turns off the heater
	when a jet pump is turned onto high speed.
Lock-Ring	Mechanism that affixes filter cover to filter housing. To
	remove cover, turn lock-ring counter-clockwise until it
	disengages with filter housing. When replacing the filter cover,
	turn lock-wring clockwise to firmly secure the cover.
Ozone Generator	A specialized ultraviolet light that changes oxygen into ozone
	for use in the water sanitation process.
Pressure Switch	Safety device that sends a signal to the electronic control
	system that there is adequate water flow to turn the heater
	on.
Primary Pump	Produces water flow through the heater, filter, sanitation
	system and the main jets in the Aquatic Fitness System. The
	primary pump will operate automatically during filtration and
	heat cycles. This pump can also be operated manually by
	depressing the “jets” button on the Top Side Control which will
	allow you to choose between two speeds
	• Low speed for efficient water circulation during
	heating and filtration modes, and for gentle jet
	resistance or massage action.
	• High speed for maximum jet action.
Pump Union	A removable fitting that connects the pump to the Aquatic
	Fitness System’s plumbing.
Selector Valve	Located on the top edge of the Aquatic Fitness System or
	spa, it diverts jet power from one area of the Aquatic Fitness
	System or spa to another.
Serial Number	Please use the serial number in communication with your
	dealer.
Servicing Filter Element	To clean or replace the filter element, shut off power to the
	Aquatic Fitness System, loosen the lock-ring, remove the filter
	cover and pull the filter element from the filter housing.
	Depending upon use, you may simply rinse the filter element
	with a garden hose, or you may be required to soak the
	element in Filter Cleaner Solution. Replace any worn or
	damaged filter elements. It is always good practice to have a
	spare filter element, so that you can perform cleaning at your
	convenience.

37