Dimension One Spas 01510-1030E Rev A manual Connecting Wires for Power Input

Export Sonic Immersion System Dealer Installation Guide

1.Speaker Output Terminals. 2. Power Input Terminals 3. Red Wire 4. Blue Wire 5. Black Wire

Figure 19. Connecting Wires for Power Input

8.Locate the wire coming from the sub-woofer. This wire is covered with clear insulator. The wire has two conductors. One is copper-colored and the other is silver. Strip approximately ½ inch (1.27 cm) of insulator from each wire and twist each to form a tight bundle. Connect the copper colored wire to the terminal marked” CH2 (REAR) + LEFT”. Connect the silver colored wire to the terminal marked” CH2 (REAR) – RIGHT”, Figure 20.

1. Copper Wire 2. Silver Wire

Figure 20. Connecting Wires to Speaker Output

9.Connect red and white preamp input wires to the Line Level Input terminals as follows: connect Channel 1 (flat speaker)

23