ASSEMBLING GUARDS TO FENCE BODY
1.Assemble guard bracket (A) Fig. 24, and hex rod (B) to upright hex shaft (C) as shown.
2.Assemble two guard brackets (A) Fig. 25, and clear plastic guard (D) to holddown (E) as shown.
3.Assemble holddown/clear plastic guard assembly to hex rod (B) as shown in Fig. 26.
4.Assemble guard bracket (A) Fig. 27, and spring clamp (F) to hex rod (B) as shown, then tighten all wing nuts.
5.The spring guard (F), holddown (E) and clear plastic guard (D) can be flipped up out of the way as shown in Fig. 28, by lifting up on locking lever (G), when not in use or when making adjustments. CAUTION: When the guard assembly is in the down position as shown in Fig. 27, make certain locking lever (G) is in the locked position as shown.
B
A
G 
F
Fig. 27
C
A
B
Fig. 24
A
A
E
D
Fig. 25
B
Fig. 26
F
E
G
D
Fig. 28
11