Unpacking and Cleaning

ADDITIONAL SAFETY RULES FOR WOOD SHAPERS

(continued)

23.WHEN SHAPING with collars and starting pin, the cutter should be positioned below the collar whenever possible, as shown in Fig. F.

Fig. F

24.MAKE all adjustments with the power “OFF”.

25.KEEP guard in place at all times.

26.BEFORE leaving the machine, make sure the work area is clean.

27.SHOULD any part of your shaper be missing, damaged or fail in any way, or any electrical component fail to perform properly, shut off switch and remove plug from power supply outlet. Replace missing, damaged or failed parts before resuming operation.

28.ADDITIONAL INFORMATION regarding the safe and proper operation of this product is available from the National Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-3201, in the Accident Prevention Manual for Industrial Operations and also in the Safety Data Sheets provided by the NSC. Please also refer to the American National Standards Institute ANSI 01.1 Safety Require- ments for Woodworking Machinery and the U.S. Depart- ment of Labor OSHA 1912.213 Regulations.

29.SAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others.

Carefully unpack the shaper and fence system from the shipping containers. Clean all loose parts and remove the protective coating from the machined surfaces of the shaper table. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline, or lacquer thinner for this purpose). Figures 2 and 3, illustrate the shaper and all loose items supplied with the machine. Fig. 4, illustrates the items supplied with the fence system.

Fig. 2