6.Fig. 29, illustrates complete fence and guard assembly mounted in the alternate position, 90 degrees to miter gage slot.
ASSEMBLING AND CHANGING SPINDLES
MAKE CERTAIN THE MACHINE IS DISCONNECTED FROM THE POWER SOURCE.
1.Thread one end of the tie rod (A) Fig. 30, into the threaded hole in the bottom of the spindle (B).
2.Insert tie rod and spindle into the spindle cartridge, making sure the pin (C) Fig. 31, in the spindle cartridge, is engaged with notch (D), in the spindle.
3.Fig. 32, illustrates the spindle (B), inserted into the spindle cartridge.
4.Thread nut (E) Figs. 30 and 33, onto bottom end of tie rod (A).
5.Place wrench on flats (F) Fig. 32, on top of spindle and tighten nut (E) Fig. 33, on bottom of tie rod to fasten spindle to spindle cartridge.
F 
B
Fig. 32
Fig. 29
B
A
E 
Fig. 30
D
C
Fig. 31
A 
E
Fig. 33
12