GB A
H
F
F 
G
H 
L 
L
FK 
K
Fig. 9
ASSEMBLING SWITCH BRACKET AND ON/OFF SWITCH
1.The on/off switch (A) Fig. 9, and switch mounting bracket (B) are shipped inside the shaper cabinet. Open the side door of the shaper cabinet, remove switch package and remove packaging material.
2.Position switch mounting bracket (B) Fig. 10, so holes (C) are over hole (D) in shaper cabinet (E), then fasten bracket (B) to cabinet (E) using four truss head screws (F) Fig. 9, flange nuts (G) and two switch adapter plates (H). NOTE: Switch adapter plates (H) are to be positioned inside the shaper cabinet as shown in Fig.
3.Fig. 12, illustrates switch mounting bracket (B) properly mounted to shaper cabinet.
4.Assemble on/off switch (A) Fig. 9, to switch mounting bracket (B) Fig. 12, through two holes (J), using two Phillips head screws (K) Fig. 9, and Keps nuts
(L).
5.Fig. 13, illustrates on/off switch properly mounted to switch mounting bracket.
B
E
D 
C
C
Fig. 10
H
H
Fig. 11
B
J
Fig. 12
Fig. 13
8