Krell Industries KCT manual Front Panel Description, Power, Remote Control Functions

Page 13

Front Panel Description

See Figure 1 on page 8

The KCT preamplifier front panel provides power on, input and zone selection, level control, menu functions, and status display. Front panel features and their descriptions follow.

Power

1 Power Button

Use this button to switch the KCT between the stand-by and the operational modes.

2 Stand-by LED

The red stand-by LED illuminates when the KCT is plugged into a standard AC wall receptacle, indicating that the KCT is ready to be switched to the operational mode.

3 Power LED

The blue power LED illuminates when the KCT is in the operational mode and flashes when remote control signals are received.

Remote Control Functions

4 Infrared Sensor

The infrared sensor receives commands from the KCT remote control. For proper remote control operation, make sure the infrared sensor is not covered or obstructed.

5 Infrared Transmitter LED

The infrared transmitter LED flashes when the KCT sends infrared signals to another remote control. See Program Remote Menu, on page 31.

Preamplifier Functions

6 Input Select Buttons

Use these buttons to select the corresponding rear panel input that is connected to a CAST (C-1, C-2), balanced (B-1, B-2), or single-ended (S-1, S-2, S-3) analog source. The front panel display (13) shows the active zone, the selected input, and volume level.

7 Tape Button

Use this button to select the corresponding rear panel input that is connected to a analog tape source. When TAPE is activated, the front panel display (13) shows the zone that is the pathway for the tape output. See Tape Output Menu, on page 30.

8 Mute Button

Use this button to mute the preamplifier output. To unmute, press the mute button again. To customize mute button operation, see Mute Menu, on page 29.

Krell Current Tunnel

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Krell Current Tunnel Cast Preamplifier Instructions for Use Owner’s ReferenceKCT Contents List of Illustrations Definition of Terms IntroductionKrell Link Theater ThroughputOperational Mode Krell Current Audio Signal Transmission CastStand-by Mode Krell Current ModeRevolutionary Krell Cast Technology How Cast and Krell Current Mode InteractCast a New Approach Cast BasicsBest Musical Performance AC Power Guidelines PlacementUnpacking Quick Start Connecting the KCT PreamplifierOperating the KCT Preamplifier If you wish to turn your system off KCT Front Panel Remote Control Functions PowerFront Panel Description Preamplifier FunctionsLevel Control DisplayMenu Functions KCT Back Panel Inputs Back Panel DescriptionTape Output Main Zone OutputsBack Panel Remote Connections Phono Stage ConnectorKCT Remote Control Battery Installation and Removal Remote Control DescriptionAmplifier Functions 38 Z2 Key Main Zone KeyInput Select Keys Tape KeyCompact Disc Functions Input and Output Connections Connecting the KCT Preamplifier to Your SystemKrell Link Connections and Operation Connecting Components through Krell LinkKrell Link Operation Tape Input and Output ON/OFF and STAND-BY Operation Operating the KCT PreamplifierTo turn off this option Main Zone and Zone 2 OperationMain Zone Only Play and Record Zone 2 OnlyTo stop recording Troubleshooting System Noise Customizing the KCT Preamplifier To adjust the fixed offset for zoneZ1 and Z2 Balance Input Name MenuInput Balance Trim Input Level TrimTheater Throughput Mode Brightness Output Trigger SetupMute Menu AC Mains Menu Tape Output MenuProgram Remote Menu Input Trigger SetupKrell Link Setup MemoryExit Menu Trigger Delay SetupQuestions and Answers Warranty Return Authorization Procedure Tape Loop SpecificationsTHD+Noise Page Krell Industries, Inc Connair Road Orange, CT 06477-3650 USA
Top Page Image Contents