PROGRAM REMOTE MENU
This option allows the KCT to send its remote control commands to a learning or programmable remote control.
Note
You must place the programmable remote in front of the KCT infrared sensor to send remote control commands.
1.Press the menu button (15) or key (41) to access the main menu.
2.Use the level control knob (14) or level keys (44) to select PROGRAM REMOTE MENU.
3.Press the enter button (16) or key (42). The front panel display (13) shows S1 SELECT (the default).
4.Use the level control knob (14) or level keys (44) to scroll through all the remote control command options.
5.Press the enter button (16) or key (42). The front panel display (13) shows
TRANSMITTING.
6.To select additional commands, press the enter button (16) or key (42) to return to the program remote menu.
7.Repeat steps 4 and 5 to select and transmit additional commands.
8.The last command on the submenu is EXIT. Select EXIT and press the enter button (16) or key (42) to return to the main menu.
9.Press the menu button (15) or key (41) to exit the menu mode.
INPUT TRIGGER SETUP
This option allows you to configure which zone is activated by the 12 VDC (12 Volt trigger) input.
1.Press the menu button (15) or key (41) to access the main menu.
2.Use the level control knob (14) or level keys (44) to select INPUT TRIGGER SETUP.
3.Press the enter button (16) or key (42). The front panel display (13) shows TURN ON BOTH (the default).
4.Use the level control knob (14) or level keys (44) to select the preferred input trigger
setup option (TURN ON BOTH, INACTIVE, TURN ON ZONE 1, TURN ON ZONE 2).
5.Press the enter button (16) or key (42) to return to the main menu or press the menu button (15) or key (41) to exit the menu mode.
Krell Current Tunnel | 31 |