Country Home Products C163-CHP instruction manual Oil

Page 13

SECTION III - OPERATION

BEFORE STARTING ENGINE, ALWAYS CHECK OIL LEVEL!

Refer to the engine owner’s manual for further details

regarding OPERATION AND MAINTENANCE OF the engine.

NOTE: ENGINE IS SHIPPED WITHOUT OIL! FILL CRANKCASE WITH OIL BEFORE STARTING ENGINE. BE VERY CAREFUL NOT TO ALLOW DIRT TO ENTER THE ENGINE WHEN CHECKING OR ADDING OIL OR FUEL.

NOTE: IF YOU START THE ENGINE WITHOUT OIL, THE ENGINE WILL BE DAMAGED BEYOND REPAIR AND WILL NOT BE COVERED UNDER WARRANTY.

BEFORE STARTING: Oil and Gas Fill-Up

Oil Capacity:

1 ½ quarts (48 ounces)

Fuel Capacity:

9 quarts

OIL

•Use a high quality detergent oil classified “For Service SF, SG, SH, SJ” or higher.

•Do not use special additives.

•Choose a viscosity according to the following table.

*CAUTION: Air cooled engines run hotter than automotive engines. The use of non-synthetic multi-viscosity oils (5W-30, 10W-30, etc.) in temperatures above 40 deg. F (4 deg. C) will result in higher than normal oil consumption. When using a multi-viscosity oil, check oil level more frequently.

**CAUTION: SAE 30 oil, if used below 40 deg. F (4 deg. C), will result in hard starting and possible engine bore damage due to inadequate lubrication.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents DR Chipper Intended USE Section I Safety080-0967 080-0970 091-0055 091-0057 091-0059 091-0062 091-0088 091-0093 091-0256 091-0384 Training Safe Operation PracticesPreparation Operation Towing Maintenance and StorageSave These Instruction For Future Reference Your ResponsibilityPackage Contents Section II Assembly InstructionsStep III Attaching the Hitch Arms and Trailer Hitch Assembly Step IV Attaching Wire Harness OIL Checking and Adding OIL FuelAdding Fuel Starting and Operating Tips Starting and StoppingTo Start Engine To Stop EngineProcessing Limbs or Branches Safety FirstPage To Free a Jammed Flywheel Section V Maintenance and Storage Knife Information Knife SharpeningWear Plate Knife InstallationChanging OIL Belt Replacement Instructions for Adjusting or Replacing Belt Belt AdjustmentDo not operate at less than full RPM’s Centrifugal Clutch Tech TipsDisassembly of Existing Clutch Clutch MaintenanceInstallation of a NEW Clutch Clutch RemovalQty Description Clutch BreakdownSymptom Problem Correction TroubleshootingBreak Lubrication and MaintenanceSection VI Parts List & Assembly Drawings Item # QTY Description C163-CHP Parts ListPage Chipper Basic Machine Item # QTY Description Accessories for C163-CHPPage Page Page Country Home Products
Top Page Image Contents