3.SETUP
AC Power
Resetting the Breaker
This product has a fixed voltage power supply and can work with an input voltage of either 120 V, 60 Hz or 230 V, 50 Hz, depending on the specific model.
To determine the power requirements for this product (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or see the Technical Specifications. The listed current rating indicates the product’s average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse), making sure that it has an appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0~100% switch.
This product uses a resettable circuit breaker. Follow the instructions below to reset.
Disconnect this product from the power outlet before resetting the breaker.
This product is equipped with a resettable circuit breaker on the power input circuit.
1.Remove the power cord from the power outlet.
2.Allow unit to cool for 15 minutes.
3.After 15 minutes, you may attempt to reset the breaker by pressing the button with your index finger until it latches in the operation position.
4.Plug the product’s power cord into the power outlet and continue using as recommended.
If the breaker does not reset (the breaker button will not remain inserted), contact CHAUVET® immediately, as this indicates a possible internal malfunction.
Arena™ 2100 Flex User Manual (Rev. 7) | Page 7 of 13 |