|
|
| Technical Information | |
|
|
|
|
|
| Troubleshooting Guide |
|
| |
| Symptom | Cause(s) | Action(s) |
|
|
| Dimmer fader set to “0” | Increase the value of the dimmer channel |
|
|
| color fader set to “0” | Increase the value of the color channel | |
|
| All colors in CUSTOM mode | Increase the values of the colors | |
| Product does not light up | are set to “0” | ||
|
|
| ||
|
| No power | Verify external power circuit and wiring | |
|
| Faulty internal power supply | Send unit for repair | |
|
| Faulty main control board | ||
|
|
|
| |
| Continuous gobo | Gobo plate #1 missing or in wrong | Verify Gobo plate #1 is correctly installed | |
| rotation | location | ||
|
|
| ||
| One of the LEDs does | Faulty LED |
|
|
| Faulty LED module | Send unit for repair | ||
| not work | |||
| Faulty LED driver |
|
| |
|
|
|
| |
| Circuit breaker/fuse | Excessive circuit load | Reduce total load placed on the electrical circuit | |
| keeps tripping/blowing | Short circuit along the power wires | Check electrical wiring |
|
|
| No power | Check for voltage on outlet | |
| Unit does not power up | Loose or damaged power cord | Check power cord | |
| Blown fuse | Replace fuse | ||
|
| |||
|
| Faulty internal power supply | Send unit for repair | |
|
|
|
|
|
|
| Wrong DMX addressing | Check unit addressing | |
|
| Damaged DMX cables | Check DMX cables | |
|
| Wrong polarity on the controller | Check polarity switch settings on the controller | |
|
| Loose DMX cables | Check cable connections | |
|
| Non DMX cables | Use only DMX compatible cables | |
| Unit does not respond to | Bouncing signals | Install terminator as suggested | |
| Long cable / low level signal | Install an optically coupled DMX splitter before a | ||
| wired DMX or responds | |||
|
| long section of cable or right after the unit with | ||
| erratically |
| ||
|
| the strong signal | ||
|
|
| ||
|
| Too many units | Install an optically coupled DMX splitter after unit | |
|
|
| #32 |
|
|
| Interference from AC wires | Keep DMX cables separated from power cables | |
|
|
| or fluorescent/black lights | |
|
| Faulty DMX interface board | Send unit for repair | |
|
| Faulty Display/Main board | Send unit for repair | |
|
|
|
|
|
If you still experience technical problems after trying the above solutions or if you need to send the unit for repair, contact CHAUVET® Technical Support.