Panama® Halo
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
getting started
Carton Contents
The fan carton contains the fan body, warranty card, owner’s manual, and all the parts neccessary ( except blades) to assemble and install your Casablanca ceiling fan. These parts are shown at the start of each installation section. before you start, go through thie Owner’s manulas and confirm thaat you have all the parts shown in each section. Be Sure to use only genuine Casablanca blades, The blade shrink wrap holds 5 blades of matched weight. If more than one fan is being installed, be sure not to mix blade sets
Caution: When removing the shrink wrap, be careful not to scratch the blades.
perma•lock™ hardware
ALLEN SET
SCREW
downrod & Ball
3mmassembly allen wrench
Fan preparation
important safety information!
before starting the installation of your ceiling fan, install the threaded downrod into the motor coupling and lock the assembly
motor ground
wires 
wire
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is de- signed to lock completely when correctly installed.
Step B. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down- rod before securely tightening the set screw may cause the fan to separate from the downrod during normal operation!
tapered
thread
ALLEN
SET SCREW
downrod
& Ball
assembly
motor
coupling
CEILING HARDWARE
CROSSBAR | WIRE NUT (4) |
MOUNTING |
|
BRACKET |
|
additional hardware
21/4” x
1” x | FLAT WASHER |
head screws (2) | (2) |
support installation
Lag screw | large flat |
3/8”7 x 5” | washer 3/8” |
3