Casablanca Fan Company 66HXXF warranty Speed operation, Speed optional Light Fixture installation

Optional light pull Chain switch

4-SPEED

4 - speed operation

Pull-chain switches on the fan control the fan and lights. Using the fan control pull-chain switch: Fan off

at start.

First pull: fan ON, High speed

Second pull: Medium speed

Third pull: Medium Low speed

Fourth pull: Low speed

Fifth pull: Fan OFF

The sequence of Light pull chain as follows: Light off at Start

First pull: Up Light

Second pull: Down Light (Optional Light Kit If Installed)

Third pull: Up & Down Light

Fourth pull: Off

Direction of blade rotation is controlled by the reverse slide switch on the side of the switch housing. No changes in household wiring are required.

Fan & speed control pull chain switch

reverse

4 - speed optional Light Fixture installation

1.Refer to light kit instructions to assemble and attach your light kit correctly.

2.Remove the two 8-32 screws from the switch housing cap.

3.Remove the plug from switch housing.

4.Install pull-chain switch and Finger tighten collar on switch.

5.Connect one wire from pull-chain switch to the

BLUE D1-Option wire. Secure splice with a wire nut.

6.Connect other wire from pull-chain switch to BLACK wire from light kit. Secure splice with a wire nut.

7.Connect WHITE wire from switch housing to WHITE wire from light kit. Secure splice with a wire nut.

8.At the canopy, connect the BLACK and BLUE wires.

switch	collar
housing
white	Blue d-1
black

light fixture

4 - speed optional Wall Control w-41

The W-41 wall control provides four-speed control of fan from a convenient wall location. The W-41 is designed to replace a standard wall switch and will fit wall boxes with a depth of 2” or greater. Not for use with single

pull-chain fan/light option wiring. To install a W-41 wall control in

place of an existing wall switch, follow the instructions on the W-41 package. Note: No rewiring is required if the fan is replacing an existing light Fixture.

Operation of the fan from the wall switch is simple: 1. Turn knob to obtain desired speed setting.

CAUTION! Failure to set the pull-chain speed to HIGH can result in faulty operation of the fan and damage to the W-41 wall control. To confirm fan is set to HIGH: TurnW-41 fan speed switch to ‘HI’ - set fastest fan speed with pull chain.

7